1993 FORD F800 — Problems, Recalls & Safety Data

Recall 95V143000 — VEHICLE SPEED CONTROL

October 25, 1995 | 29,000 vehicles affected

Defect: THE HAND THROTTLE CABLE CAN WEAR THE BRASS SWIVEL BLOCK ON THE GOVERNOR LEVER THROUGH WHICH IT PASSES.

Consequence: THIS WEAR CAN RESULT IN THE GOVERNOR JAMMING IN THEDAMAGED SWIVEL AND COULD PREVENT THE GOVERNOR LEVER FROM RETURNING TO THE IDLE POSITION.

Remedy: DEALERS WILL INSTALL A REVISED GOVERNOR LEVER WITH A STAINLESS STEEL SWIVEL. ALSO LETTERS WILL BE SENT TO VEHICLE OWNERS THAT HAVE THE SAME VEHICLES BUT DO NOT HAVE A FORD INSTALLED HAND THROTTLE ADVISING THEM THAT THEY MAY REQUIRE...

View full details →

Recall 93V160000 — VEHICLE SPEED CONTROL:SPRINGS

December 23, 1993 | 20,000 vehicles affected

Defect: AS A RESULT OF INHERENT VIBRATION IN THESE ENGINES, THE THROTTLE RETURN SPRINGS CAN FRACTURE.

Consequence: IF ONE OF THE TWO RETURN SPRINGS FRACTURES WHILE THEVEHICLE IS BEING DRIVEN, A SUBSTANTIAL REDUCTION IN ACCELERATOR PEDAL EFFORTWOULD BE FELT. IF THE SECOND SPRING ALSO FRACTURES, THE THROTTLE WOULD NOTRETURN TO IDLE POSITION AND CAN RESULT IN INCREASED ENGINE SPEED AND THEPOSSIBILITY OF LOSS OF VEHICLE CONTROL AND AN ACCIDENT.

Remedy: THE THROTTLE RETURN CONTROL SYSTEM WITH THE COIL TORSION SPRING DESIGN WILL BE REPLACED.

View full details →

Recall 92V164000 — WHEELS

February 5, 1993 | 192 vehicles affected

Consequence: USING THE WRONG SIZED CLAMPS TO ATTACH THE RIM AND TIREASSEMBLY TO THE WHEEL SPOKES COULD CAUSE THE STUDS THAT ATTACH THE CLAMPS TO THESPOKES TO BEND. IF THE STUDS ARE BENT, THERE IS AN INCREASED RISK OF STUDFRACTURE THAT COULD RESULT IN THE RIM AND TIRE ASSEMBLY BREAKING FROM THEWHEEL.

Remedy: REPLACE THE CLAMPS AND STUDS ON THE CAST SPOKE WHEELS.

View full details →

Recall 95E003008 — SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

| 3,500 vehicles affected

Defect: AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVERPRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM...

Consequence: IF THE AIR DRYER SEPARATES FROM THE BASE, THE CARTRIDGE CAN SEPARATE SUFFICIENTLY ENOUGH TO CAUSE PERSONAL INJURY OR PROPERTY DAMAGE.

Remedy: DEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.

View full details →