1997 DODGE DODGE TRUCK — Problems, Recalls & Safety Data

FOR SEVERAL YEARS I HAVE BEEN EXPERIENCING A SUDDEN LOSS OF MY HEADLIGHTS WHILE DRIVING MY 1997 DODGE RAM 1500 WITH 82000 MILES ON IT. I NOTICED THAT I EXPERIENCED THIS PROBLEM MUCH MORE OFTEN WHEN OPERATING THE HIGH BEAMS FOR 10-15 MINUTES. I TOOK IT IN TO A SERVICE SHOP ON TWO OCCASIONS BUT THEY COULD NEVER DIAGNOSE THE PROBLEM. ON 12/28/08, I BEGAN SMELLING AN ELECTRICAL SMELL IN THE CAB AND THE HEADLIGHTS SUDDENLY WENT OUT. I PULLED TO THE SIDE OF THE ROAD AND TURNED THE TRUCK OFF. AFTER 10-15 MINUTES, THE HEADLIGHTS WORKED AGAIN. THE NEXT DAY I DISCOVERED THAT THERE HAD BEEN A RECALL ISSUED (#819) FOR 1994-1997 DODGE RAM 3500 SERIES FOR THIS EXACT PROBLEM. HOWEVER, BECAUSE MY TRUCK IS A 1997 RAM 1500, THE DEALER SAYS THE RECALL DOESN'T APPLY AND THEY REFUSE TO FIX IT. THE RECALL NOTICE DESCRIBES THE EXACT PROBLEM AND THE FACT THAT IT IS SAFETY AND FIRE HAZARD. THE DEALER SAYS THAT SINCE IT IS NOT IN THERE RECALL DATABASE THEY ARE NOT OBLIGATED TO REPAIR IT AND THAT I MUST FIX IT AND THEY WILL NOTIFY ME LATER IF IT DOES GET RECALLED. THEY TOLD ME TO KEEP MY RECEIPTS. THE COST IS ONE THING BUT WHAT REALLY UPSETS ME IS THE HAZARD THIS PROBLEM CREATES AND THEIR RESPONSE TO IT! *TR

FOR SEVERAL YEARS I HAVE BEEN EXPERIENCING A SUDDEN LOSS OF MY HEADLIGHTS WHILE DRIVING MY 1997 DODGE RAM 1500 WITH 82000 MILES ON IT. I NOTICED THAT I EXPERIENCED THIS PROBLEM MUCH MORE OFTEN WHEN OPERATING THE HIGH BEAMS FOR 10-15 MINUTES. I TOOK IT IN TO A SERVICE SHOP ON TWO OCCASIONS BUT THEY COULD NEVER DIAGNOSE THE PROBLEM. ON 12/28/08, I BEGAN SMELLING AN ELECTRICAL SMELL IN THE CAB AND THE HEADLIGHTS SUDDENLY WENT OUT. I PULLED TO THE SIDE OF THE ROAD AND TURNED THE TRUCK OFF. AFTER 10-15 MINUTES, THE HEADLIGHTS WORKED AGAIN. THE NEXT DAY I DISCOVERED THAT THERE HAD BEEN A RECALL ISSUED (#819) FOR 1994-1997 DODGE RAM 3500 SERIES FOR THIS EXACT PROBLEM. HOWEVER, BECAUSE MY TRUCK IS A 1997 RAM 1500, THE DEALER SAYS THE RECALL DOESN'T APPLY AND THEY REFUSE TO FIX IT. THE RECALL NOTICE DESCRIBES THE EXACT PROBLEM AND THE FACT THAT IT IS SAFETY AND FIRE HAZARD. THE DEALER SAYS THAT SINCE IT IS NOT IN THERE RECALL DATABASE THEY ARE NOT OBLIGATED TO REPAIR IT AND THAT I MUST FIX IT AND THEY WILL NOTIFY ME LATER IF IT DOES GET RECALLED. THEY TOLD ME TO KEEP MY RECEIPTS. THE COST IS ONE THING BUT WHAT REALLY UPSETS ME IS THE HAZARD THIS PROBLEM CREATES AND THEIR RESPONSE TO IT! *TR

1997 DODGE RAM HAS DASHBOARD COVER CRACKED IN SEVERAL PLACES. PIECES HAVE FALLEN DOWN INTO THE DASH AMONG THE INTERNAL WIRING. THIS IS NOT JUST A COSMETIC PROBLEM. IF THE PIECES THEMSELVES DO NOT SHORT OUT THE WIRING AND CAUSE A FIRE, THE JAGGED EDGES COULD POTENTIALLY CUT OPEN AN AIRBAG UPON DEPLOYMENT CAUSING A BAG FAILURE DURING A CRASH. *TR

IT WAS REQUESTED THAT DODGE DAKOTA OWNERS LOG INFORMATION AS TO IF THEY HAVE EXCESSIVELY WORN BALL JOINTS AND / OR FAILURES. I AM AN ENGINEER AT AN EQUIPMENT MANUFACTURER AND BELIEVE THIS IS A FAILURE DUE TO EXCESSIVE WEAR AT LOW MILEAGE. MY 1997 DAKOTA SLT HAS 70,000 MILES ON IT NOW AND SINCE I DO NOT DRIVE IT MUCH I WAS HOPING THERE WOULD BE RECALL BEFORE IT WAS NECESSARY TO REPLACE THE JOINTS.A NUMBER OF CAB PLASTIC ISSUES WHICH WERE DESIGN CHANGED (YEAR OR TWO LATER) AND NOT RECALLED, MISC ITEMS BREAKING - DRIVERS WINDOW SWITCH PLATE, AUTOMATIC GEAR SELECTOR HANDLE CRACKING, ASH TRY PIVOT POINT (NON-SMOKER - BROKE WHEN I TRIED TO CLEAN IT!). NOT TO MENTION THE 3.9 L ISSUES OF POOR ACCELERATION / RESPONSE DUE TO WHAT IT SOUNDS IS A PRODUCTION TOLERANCE ISSUE WITH THROTTLE POSITION SENSORS. FINALLY THE TRANSMISSION SHIFT POINTS AND CLUTCH FILL TIMES DO NOT SEEM TO HAVE MUCH TIME SPENT ON THEM. THE POSITIVE AND NEGATIVE GRADING OF THE TRUCK IS HORRIBLE DUE TO NUMEROUS SHIFTS, NO (OR NOT ENOUGH) ANTI-HUNTING TIME FOR HOLDING A DOWNSHIFT. I AM PROVIDING MY INFORMATION AS TO FURTHER ADD TO THE DATABASE OF CONSUMERS THAT FEEL SOMETHING NEEDS TO BE DONE ABOUT THESE POOR DESIGN ISSUES.*AK

IT WAS REQUESTED THAT DODGE DAKOTA OWNERS LOG INFORMATION AS TO IF THEY HAVE EXCESSIVELY WORN BALL JOINTS AND / OR FAILURES. I AM AN ENGINEER AT AN EQUIPMENT MANUFACTURER AND BELIEVE THIS IS A FAILURE DUE TO EXCESSIVE WEAR AT LOW MILEAGE. MY 1997 DAKOTA SLT HAS 70,000 MILES ON IT NOW AND SINCE I DO NOT DRIVE IT MUCH I WAS HOPING THERE WOULD BE RECALL BEFORE IT WAS NECESSARY TO REPLACE THE JOINTS.A NUMBER OF CAB PLASTIC ISSUES WHICH WERE DESIGN CHANGED (YEAR OR TWO LATER) AND NOT RECALLED, MISC ITEMS BREAKING - DRIVERS WINDOW SWITCH PLATE, AUTOMATIC GEAR SELECTOR HANDLE CRACKING, ASH TRY PIVOT POINT (NON-SMOKER - BROKE WHEN I TRIED TO CLEAN IT!). NOT TO MENTION THE 3.9 L ISSUES OF POOR ACCELERATION / RESPONSE DUE TO WHAT IT SOUNDS IS A PRODUCTION TOLERANCE ISSUE WITH THROTTLE POSITION SENSORS. FINALLY THE TRANSMISSION SHIFT POINTS AND CLUTCH FILL TIMES DO NOT SEEM TO HAVE MUCH TIME SPENT ON THEM. THE POSITIVE AND NEGATIVE GRADING OF THE TRUCK IS HORRIBLE DUE TO NUMEROUS SHIFTS, NO (OR NOT ENOUGH) ANTI-HUNTING TIME FOR HOLDING A DOWNSHIFT. I AM PROVIDING MY INFORMATION AS TO FURTHER ADD TO THE DATABASE OF CONSUMERS THAT FEEL SOMETHING NEEDS TO BE DONE ABOUT THESE POOR DESIGN ISSUES.*AK