2005 CHEVROLET SILVERADO 3500 — Problems, Recalls & Safety Data

WHILE DRIVING AND TOWING A 9000# TRAILER NOTICED BRAKE PEDAL WAS GETTING A LITTLE SPONGY. STOPPED AT REST AREA AND CHECKED THE FLUID AND NOTICED IT WAS QUITE LOW. LOOKED UNDER THE TRUCK AND COULD SEE FLUID DRIPPING FROM A BRAKE LINE. MECHANIC PUT THE TRUCK ON THE RACK AND SHOWED WHERE ALL THE BRAKE LINES WERE RUSTED AND THE ONE HAD RUSTED THROUGH. MECHANIC SAID THIS IS A KNOWN PROBLEM WITH THIS MODEL TRUCK. REPLACE ALL METAL BRAKE LINES WITH STAINLESS STEEL LINES, ALSO REPLACE ALL THE RUBBER LINES AS A PRECAUTION.

THE BRAKE LINE ABOVE THE FUEL TANK BLEW OUT. IT WAS NOT GRADUAL EITHER. THE PREVIOUS STOP GAVE ABSOLUTELY NO WARNING. THE NEXT STOP BRAKE INSTANTLY WENT TO THE FLOOR.

TL* THE CONTACT OWNS A 2005 CHEVROLET SILVERADO 3500. WHILE DRIVING 70 MPH, THE VEHICLE STALLED WITHOUT WARNING. THE CONTACT WAS UNABLE TO RESTART THE VEHICLE. THE VEHICLE WAS TOWED TO LUCAS CHEVROLET (4323, 101 S JAMES CAMPBELL BLVD, COLUMBIA, TN 38401, (931) 398-5092) WHERE IT WAS DIAGNOSED THAT THE FUEL SYSTEM NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 220,000.

AS PREVIOUSLY STATED I OWN A 2005 3500 HD SERIES CHEVY DIESEL TRUCK. THE TRUCK HAS LESS THAN 80,000 MILES ON IT AND HAS ALWAYS BEEN IN RELEIGH, NC. THE TRUCK HAS NOT BEEN IN A HEAVILY NORTHERN ROAD SALTED AREAS. LAST WEEK WHEN I WENT TO RUN AN ERRAND THE BRAKE PEDAL WENT ALL THE WAY TO THE FLOOR BOARD. WHEN I INSPECTED THE BRAKE LINES THE REAR BRAKE LINE HAD RUPTURED. I FIXED THAT LINE AND WHILE TEST DRIVING THE TRUCK THE OTHER FOUR LINES TO THE ABS AND FRONT BRAKES ALSO RUPTURED. I HAVE VEHICLES THAT ARE UP TO THIRTY YEARS OLD THAT I DRIVE ON A REGULAR BASIS AND THEY STILL HAVE THEIR ORIGINAL BRAKE LINES THAT ARE IN GOOD WORKING ORDER. THE BRAKE LINES ON THIS TRUCK HAVE A LATENT DEFECT. THE DEFECT IS THE RESULT OF EITHER POOR DESIGN OR MATERIAL SELECTION OR BOTH. THE BRAKE LINES ARE PROBABLY NOT MANUFACTURED IN THE USA TO OUR STRICT STANDARDS , BUT MANUFACTURED IN EITHER CHINA, MEXICO OR INDIA TO LESS STRICT MANUFACTURING AND OSO STANDARDS. IF THE BRAKES HAD FAILED ON THE ROAD AND NOT IN THE DRIVEWAY IT COULD HAVE RESULTED IN TERRIFIC AND UNNECESSARY ACCIDENT. KEEP IN MIND THE TRUCK WEIGHS ALMOST 8000 LBS. AND TRAVELING AT 65 MPH THERE IS NOT MUCH THAT CAN STOP IT EXCEPT A CONCRETE WALL. THE ABOVE DESCRIBE ACCIDENT WHICH COULD ONLY BE CAUSED BY GENERAL MOTORS BASIC LACK OF INTEREST IN PUBLIC SAFETY AND WELFARE. GM SHOULD BE DECLARED RESPONSIBLE FOR MY THE BRAKE FAILURE AND THEREFORE FOUND RESPONSIBLE FOR THE REPAIRS TO MY TRUCK AND THE COUNTLESS OTHER TRUCKS OUT THAT HAVE YET TO FAIL. THE BRAKES FAILED NOT FROM A LACK OF INSPECTION AND MAINTENANCE, BUT RATHER FROM GM'S INTENTIONAL LATENT DEFECT.

TL* THE CONTACT OWNS A 2005 CHEVROLET SILVERADO 3500. WHILE THE VEHICLE WAS PARKED, THE CONTACT OBSERVED THAT THE POWER STEERING FLUID WAS LEAKING FROM AN UNKNOWN AREA. THE FAILURE OCCURRED CONSTANTLY. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED THAT THE BRAKE HYDRO-BOOST UNIT WAS LEAKING AND NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE VIN WAS NOT INCLUDED IN NHTSA CAMPAIGN NUMBER: 05V043000 (SERVICE BRAKES, HYDRAULIC). THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 66,188. UPDATED 06/15/16*LJ THE CONSUMER STATED THE VEHICLE WAS REPAIRED. UPDATED 06/22/16.*JB