2012 CHEVROLET COLORADO — Problems, Recalls & Safety Data

Regarding a fuel leak on my 2012 Chevrolet Colorado WT, caused by severe corrosion of the in-tank fuel pump module. This issue is of great concern, as it poses a potential fire hazard due to fuel spray near the exhaust system. Upon reviewing official documentation, I found that Recall 17V-243 appears to address a similar defect affecting 2004–2012 Colorado and Canyon models with corrosion-prone fuel tank assemblies and retaining rings. However, my VIN does not currently show as part of that recall on NHTSA.gov. The only warning sign of a problem per GM protocol is detecting the odor of gasoline around the vehicle. The truck has not been inspected by GM, police, insurance, or anyone except myself. I have attached a video showing the leak.

The contact owns a 2012 Chevrolet Colorado. The contact stated that while inspecting the vehicle, it was discovered that the driver’s side subframe had fractured due to rust and corrosion. The contact indicated that the fracture was located by the bed of the truck and the cabin of the vehicle. The vehicle was inspected by a welder who advised that the damaged was too severe to repair and that the subframe needed to be replaced. The manufacturer and local dealer were notified of the failure, but no assistance was offered. The failure mileage was 157,000.

The hub assembly came apart while driving which disabled the steering of the vehicle. We have replaced the hub assemblies 5 times in the last year, due to faulty design of the parts, and were well aware there could be an issue because the first time it happened it didnt lock up completely while driving and would start making a squealing noise. We bought this truck in 2018 with 49000 miles on it and have put 45000 mile on the truck in the last 4 years. That's not excessive and to have to replace an assembly that is supposed to last the lifetime of your vehicle 5 times in a year and a half is ridiculous.

The hub assembly came apart while driving which disabled the steering of the vehicle. We have replaced the hub assemblies 5 times in the last year, due to faulty design of the parts, and were well aware there could be an issue because the first time it happened it didnt lock up completely while driving and would start making a squealing noise. We bought this truck in 2018 with 49000 miles on it and have put 45000 mile on the truck in the last 4 years. That's not excessive and to have to replace an assembly that is supposed to last the lifetime of your vehicle 5 times in a year and a half is ridiculous.

That truck started on fire. Burnt up. Total . It started on the front passenger side near the motor where the ground plug is located. It had drizzled that day and the ground plug is not water proof. Burnt down a huge 120 long barn with other farm equipment inside. About $250,000 in losses.