2016 CHEVROLET CAMARO Wheels Problems

The contact owns a 2016 Chevrolet Camaro. The contact stated that while driving at an unknown speed, the contact drove over a pothole and damaged the front passenger’s side tire. The vehicle was taken to an independent mechanic and the contact was informed that the part to repair the vehicle needed to be repaired by the dealer. The vehicle was then taken to a dealer where he was notified that the drive shaft was defective; however, when he arrived at the dealer, he was informed by the dealer supervisor that the center support barrier was defective. The contact disputed the claim and the dealer refused to service the vehicle. The manufacturer was notified of the issue and an investigation was performed. The contact was then informed by the manufacturer that the vehicle would not be repaired and the contact was instructed to retrieve the vehicle. The vehicle was not repaired....

TL* THE CONTACT OWNS A 2016 CHEVROLET CAMARO. WHILE DRIVING APPROXIMATELY 30 MPH, THE FRONT WHEELS SHOOK UNCONTROLLABLY. THE CONTACT LOST CONTROL OF THE VEHICLE AS IT SPUN AROUND TWICE AND CRASHED INTO A METAL DIVIDER. NONE OF THE FRONTAL AIR BAGS DEPLOYED. THERE WERE NO WARNING INDICATORS ILLUMINATED. THERE WERE NO INJURIES AND A POLICE REPORT WAS NOT FILED. THE VEHICLE WAS TOWED TO THE CONTACT'S RESIDENCE. THE VEHICLE WAS NOT TAKEN TO THE DEALER OR AN INDEPENDENT MECHANIC FOR DIAGNOSTIC TESTING. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 50,000.

I HAVE A DEFECTIVE WHEEL, IT CRACKED. THERE WAS NO IMPACT, I HAVE PICTURES AND VIDEOS OF THE WHEEL SPINNING ON A BALANCER TO PROVE THIS. THIS IS A PROBLEM THAT HAS BECOME MORE COMMON SINCE WHEEL MANUFACTURING WENT TO CHINA. GM IS WEASELING OUT OF THE WARRANTY, NO BIG DEAL. THE DANGER IS THAT I WAS INFORMED THAT GM WELDS LOW PRESSURE CAST WHEELS TO FULFILL WARRANTY CLAIMS. WHICH THE DEALERSHIP HAD DONE TO THIS WHEEL WITHOUT MY KNOWLEDGE, AGAIN NO BIG DEAL I ALREADY REPLACED THE WHEEL AND CERTAINLY WOULDN'T PUT THAT WHEEL BACK ON MY CAR. IN MY PROFESSIONAL OPINION THIS IS DANGEROUS. ESPECIALLY ON A HEAVY CAR THAT IS MADE TO RUN ON A TRACK AT 150 MPH PLUS. A CRACK IS CAUSED BY IMPURITIES IN THE ALLOY. IF THE ALLOY HAS IMPURITIES THEY USUALLY AREN'T ISOLATED TO ONE SPECIFIC SPOT. THIS CRACK ACTUALLY GREW FROM...

I WAS DRIVING DURING RUSH HOUR AT 70MPH WHEN MY AXLE SHAFT ABRUPTLY DISCONNECTED FROM THE CAR. IT WAS SHAKING VIOLENTLY, AND I WAS UNABLE TO ACCELERATE. I WAS ONLY ABLE TO COAST THROUGH THREE LANES OF TRAFFIC TO GET THE CAR OFF THE ROAD. I ALMOST DIED WHEN THE PERSON BEHIND ME ALMOST DROVE THROUGH ME WHEN THE SHAFT DISCONNECTED AND THE CAR SUDDENLY SLOWED WITHOUT THE BRAKE LIGHTS GOING OFF.

CAST FISSURE ON INSIDE OF 20" RS WHEEL BARREL