1995 CADILLAC FLEETWOOD — Problems, Recalls & Safety Data

THE CONSUMER STATED THAT HE RECEIVED A RECALL BACK IN 1999, IT DEALT WITH HAVING THE BALL JOINTS AND KNUCKLES REPLACED. HE STATED THAT AT THAT TIME, HIS DEALER TOLD HIM THAT THERE WAS NOTHING WRONG WITH HIS VEHICLE AND THAT EVERYTHING WAS OK. NOW 20,000 MILES LATER, HE FINDS THAT THE NUT HAS CHEWED THE COTTER KEY OFF AND IN HALF. HE STATED WHEN HE TOOK THE VEHICLE TO THE DEALER AND SHOWED IT TO THEM, THEY SAID THEY DID NOT HAVE TO REPAIR IT. THE CONSUMER STATED THAT HE COULD HAVE BEEN KILLED, BECAUSE HE IS TRAVELING UP AND DOWN THE HIGHWAY, AND HIS WHEEL WAS ABOUT TO COME OFF. HE STATED THAT THE DEALERS NAME IS VAN TROW OLDS AND CADILLAC DEALER, IT IS LOCATED AT 2015 LOUISVILLE AVENUE MONROE, LA 318 387 2021. HE STATES ALL HE WANTS IS HIS VEHICLE REPAIRED, WHERE THEY DID NOT REPAIR IT BEFORE. *NM THE CONSUMER HAD THE FAULTY NUT IN THE BALL JOINTS REPAIRED BY A DIFFERENT DEALER PRIOR TO MEETING WITH THE VAN-TROW DEALERSHIP. *LA *JB

DURING THE DAY THE INSTRUMENT PANEL IS VERY HARD TO SEE. LIGHT STARTS OUT BEING BRIGHT AND SLOWLY GOES DIM. INSTRUMENT PANEL AT NIGHT DOESN'T AFFECT THE DRIVER. CADILLAC WAS CONTACTED. *AK CONSUMER ALSO STATES THAT SOMETIMES SHE'S NOT ABLE TO SEE HOW FAST THE VEHICLE IS BEING DRIVEN. *SCC

WHILE BACKING OUT OF DEALERSHIP CONSUMER LOST ALL CONTROL OF VEHICLE. CONSUMER HAD TO STEP ON BRAKES TO STOP VEHICLE. CONTACTED DEALER. *AK

VEHICLE WAS NOT MOVING WHEN DRIVER'S SIDE OF VEHICLE DROPPED. LOWER BALL JOINT HAD BROKEN. REPAIRED AT DEALERSHIP.*AK CONSUMER STATED THAT THE TAPERED PART OF THE THE BALL JOINT WAS NEVER PULLED TIGHT IN THE TAPER IN THE SPINDLE, THE TAPER IN THE SPINDLE IS EGG SHAPED AND HOLLOW FROM MOVING AROUND. *SLC

WHILE DRIVING AT 68 MPH ON ROUTE 35E 40 MILES SOUTH OF DALLAS, TEXAS, THE RIGHT FRONT WHEEL CAME OFF THE CAR. ALL FIVE OF THE LUG STUDS SHEARED OF AT THE FACE OF THE ROTOR ASSEMBLY. THE TIRE WEDGED AGAINST THE LOWEST REAR PART OF THE FENDER WELL WHICH RESULTED IN A CLEAN CUT THROUGH THE TIRE SIDEWALL. I WAS TRAVELLING IN THE RIGHT HAND LANE AND WAS ABLE TO BRING THE CAR TO A SAFE STOP ON THE RIGHT SHOULDER OF THE ROAD. THE TIRE TRAVELED ABOUT 350 YARDS ACROSS THE RIGHT HAND DRAINAGE AREA AND STOPPED IN A CULTIVATED FIELD ABOUT 100 YARDS FROM WHERE I STOPPED THE CAR. THE TIRE HAD BEEN PUT ON THE CAR ABOUT THREE WEEKS PRIOR TO THIS INCIDENT AND HAD BEEN TORQUED TO THE MANUFACTURERS SPECIFICATIONS OF 100 FT/LBS. THE ROTOR REQUIRED REPLACEMENT ALONG WITH THE SHIELD THAT IS INSTALLED BEHIND THE ROTOR. THE RIGHT FRONT QUARTER PANEL (FENDER) WILL REQUIRE EXTENSIVE WORK OR REPLACEMENT. CADILLAC HAS SAID THAT THE LUG NUTS WERE OVERTORQUED AT SOME POINT. IT IS MY OPINION THAT THE STUDS FAILED BECAUSE OF THE MATERIAL THAT WAS USED IN MANUFACTURE. I FEEL THAT FAILURES OF THIS TYPE ARE SERIOUS BECAUSE OF POTENTIAL TURNOVERS AND DAMAGE THAT MAY RESULT TO OTHER VEHICLES BY THE LOOSE WHEEL.*AK