2007 BMW 3 SERIES Power Train Problems

TRANSMISSION SHIFT BADLY - LUNGES FORWARD - TENDES TO STALL -TRAVELING AT LOW SPEEDS GOES IN TO 5 OR 6 GEAR STEP ON GAS PADDLE TAKES TO LONG TO SHIFT DOWN AND JUMPS FORWARD. THIS HAS BEEN HAPPENING EVEN WHEN THE CAR WAS NEW AND GETTING WORSE AS TIME GOES ON.

I WAS PARKED, PLACED MY CAR IN REVERSE AND IMMEDIATELY ALL OF MY DASHBOARD LIGHTS WERE ACTIVATED (4X4 MALFUNCTION, ABS BRAKE FAILURE, TRANSMISSION MALFUNCTION) THEN MY CAR LOST POWER. THERE IS A KNOWN ISSUE WITH THE SET POSITIONING MOTOR FAILING ON THESE VEHICLES. THE BMW DEALER PART # IS 27 10 7 546 671. THERE IS AN INTERNAL GEAR, WITH IN THE SET POSITIONING MOTOR, MADE OUT OF PLASTIC THAT WEARS PREMATURELY. THIS IS A KNOWN ISSUE WITH BMW'S AND IT SHOULD BE RECALLED. MY VEHICLE BECOME DISABLED WITH OUT WARNING, LEAVING ME STRANDED WHICH MAY HAVE CAUSED AN ACCIDENT. *TR

WHEN I START MY CAR IT WANTS TO TURN OFF. BMW ISSUED A RECALL I TOOK IT IN TO FIX IT BUT PROBLEM STILL HAPPENING. THEN MY CAR HAS 63000 MILES AND IT KICKS A LOT IN FIRST GEAR. FOR LOW MILES THAT SHOULD NOT BE HAPPENING. *TR

MY WIFE WAS DEPARTING A TRAFFIC CIRCLE ON BASE HERE IN GERMANY. SHE ACCELERATED TO 35 MPH AND EXPERIENCED STALLED ACCELERATION AS SHE WAS TRAVELING DOWN THE MAIN ROAD. MY WIFE WAS STEPPING ON THE GAS AND THE CAR APPEARED NOT TO BE RUNNING. SHE ATTEMPTED TO GET THE VEHICLE OFF TO THE SIDE OF THE ROAD AS IT ROLLED TO A STOP. SHE WAS STUCK IN THE RIGHT HAND TURN LANE ON A TWO LANE ROAD AND WAITED FOR SECURITY FORCES PATROLMAN THAT STOPPED AND HELPED PUSH THE CAR OUT OF TRAFFIC. *TR

I BOUGHT MY BRAND NEW BMW X3 IN 2007. THERE WERE SMALL ISSUES IN THE PAST BUT WITHING MY MANUFACTURER WARRENTY PERIOD. I HAD MY REAR BRAKE PADS REPLACED ON JAN 23, 2012. ON JAN 30, 2012, WHEN I DROVE MY X3 OUT MY SUBDIVISON TO GO TO WORK, THE BRAKE LIGHT, ABS LIGHT, AND 4/4 LIGHT ALL ON, PLUS LOAD CLUNK TYPE NOISE FROM REAR, IT WAS DIFFICAULT TO MAKE A U-TURN, MANAGED BACK TO HOME, CALLED BMW UNITEDBMW DEALER AND TOWED MY VEHICLE TO DEALER. THEY FIRST TOLD ME THAT IS SOFTWARE FAILURE, THEY WOULD TRY REPROGRAM TO FIX, THEN CALLED TO TELL THE RE-PROGRAM DID NOT WORK, IT WAS MECHANICAL TRANSFER CASE ACTUATOR BROKEN, A NEW ONE MUST BE INSTALLED. THE TOTAL CHARGE FOR REPAIR (PART + LABOR - DISCOUNT) IS $2354.97. IT WAS IN THE DEALER FOR ONE WEEK. THE DEALER INSISTED THAT IT WAS MY...