Technical Service Bulletin PIP5830 — 2018 GMC CANYON
ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM)
Bulletin Details
| TSB ID | PIP5830 |
| Manufacturer | |
| Vehicle | 2018 GMC CANYON |
| Component | ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM) |
| Communication Date |
Bulletin Summary
This Preliminary information communicates concerns created by an aftermarket ECM calibration installed by fleet companies. The Fleet companies install aftermarket ECM calibrations to limit the vehicle speed to approximately 70 mph and reduce the over all power output. This calibration also reduces the engine idle speed and may induce a vibration at idle. If the vehicle needs to be returned to factory specifications, the ECM must be replaced and programmed.
About Technical Service Bulletins
A Technical Service Bulletin (TSB) is a document issued by a vehicle manufacturer to its dealers, describing a known issue with a specific vehicle or set of vehicles and the recommended procedure to fix it. Unlike recalls, TSBs are not mandatory and are typically only performed if an owner reports the related issue. However, TSBs can be an indicator of common problems with a vehicle.
Other TSBs for the 2018 GMC CANYON
22-NA-003
ENGINE AND ENGINE COOLING
22-NA-143
EQUIPMENT
PIT5569B
SERVICE BRAKES, AIR:ANTILOCK:WHEEL SPEED SENSOR
PIT5474D
EXTERIOR LIGHTING
17NA222
BACK OVER PREVENTION
22NA003
ELECTRICAL SYSTEM:WIRING
17NA394
SUSPENSION
PIT5600C
WHEELS
PIT5516E
EQUIPMENT:ELECTRICAL
20NA031
ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:BELTS AND ASSOCIATED PULLEYS