Technical Service Bulletin NTB21-014 — 2013 NISSAN TITAN
EXTERIOR LIGHTING
Bulletin Details
| TSB ID | NTB21-014 |
| Manufacturer | |
| Vehicle | 2013 NISSAN TITAN |
| Component | EXTERIOR LIGHTING |
| Communication Date |
Bulletin Summary
2012-2015 TITAN; HIGH-MOUNTED STOP LAMP SERVICE PART SERVICE INFORMATION The mounting stud diameter for the high-mounted stop lamp service part has changed from 5 mm to 6 mm. If, for any reason, the high-mounted stop lamp needs to be replaced, the mounting hole will need to be enlarged to 6.5 mm (¼ inch) as follows: 1. Remove the high-mounted stop lamp. ï· For high-mounted stop lamp removal, refer to the Electronic Service Manual: Section DRIVER CONTROLS > EXL â Exterior Lighting System > HIGH-MOUNTED STOP LAMP > Removal and Installation > HIGH-MOUNTED STOP LAMP. 2. Enlarge the high-mounted stop lampâs mounting holes (see Figure 1 on page 2) using a 6.5 mm (¼ inch) drill bit. To avoid damage to the vehicle, apply light pressure to the drill while drilling. Excessive force may cause the drill bit to penetrate too far and damage the headliner. 3. Apply touch-up paint to the mounting holes to protect the bare metal. 4. Install the new high-mounted stop lamp using M6 mounting nuts. Refer to the PARTS INFORMATION on page 2.
About Technical Service Bulletins
A Technical Service Bulletin (TSB) is a document issued by a vehicle manufacturer to its dealers, describing a known issue with a specific vehicle or set of vehicles and the recommended procedure to fix it. Unlike recalls, TSBs are not mandatory and are typically only performed if an owner reports the related issue. However, TSBs can be an indicator of common problems with a vehicle.