NHTSA Complaint #11708992 — 2019 MERCEDES-BENZ C 300

While driving at approximately 65 mph on the I-405 freeway in Irvine, CA during rainy conditions, my 2019 Mercedes-Benz C300 suddenly and completely lost acceleration without warning. At the same moment, a Check Engine Light illuminated on the dash. I was forced to coast across all lanes and stop in the emergency shoulder in a very unsafe area with high-speed traffic passing close by in low visibility rainy conditions. Multiple vehicles nearly struck us, including one that had to emergency brake directly behind my car in the shoulder. I contacted AAA and the vehicle had to be towed because it was not safe or driveable. My girlfriend was also in the car and both of us experienced significant fear and distress during and after the incident. My mechanic retrieved fault code P019185 and stated this is a known software problem with the engine control unit that requires a Mercedes software update and reset of mixture adaptations per a manufacturer LI/service document. This means the manufacturer appears aware of the defect and the required software fix, yet I received no recall notice or safety warning. A sudden total loss of engine power at highway speeds creates an extreme crash risk and life-threatening danger to the driver, passengers, and surrounding traffic. There have been other serious drivability issues with this vehicle in the past (misfires, coolant pipe failure, etc.), but this incident was the most dangerous. I am reporting this because this defect appears safety-related and could easily cause a fatality if it happens to someone else at freeway speeds. Diagnostic Note from official Mercedes-Benz Fletcher Jones of Newport Beach Mechanic: “FAULT CODE P019185, WILL START WITH PERFORMING THE SOFTWARE UPDATE OF ME CONTROL UNIT, RESET THE MIXTURE ADAPTIONS PER LI DOCUMENT AND RECHECK.” Tow Provider: AAA — tow confirmation available if needed.