NHTSA Complaint #11667564 — 2021 JEEP WRANGLER

June 5, 2025 stopped at red light turned green tried to turn left and the jeep flashed the electric red bolt symbol and check engine light came on lost all power would not go when gas pedal was pushed. a/c lost power started blowing hot air and engine turned off. Restarted engine finally got it to go enough to pull out of traffic. Turned off engine opened hood checked battery cables, fuses and all was intact. Started engine drove slowly to the Autozone store to have the diagnostic test done and it showed P2101 power train system throttle actuator A control motor circuit range /performance detected unexpected voltage on the throttle actuator control motor circuit also C121C-00 ABS torque request signal denied Anti-lock Brake System U0401-00 implausible data received from ECM/PCM “A”. System was reset to be able to drive home. 6/16/25 went to start jeep to go to work made a clicking noise check engine light on and the voltage warning sensor flashing and showed Service Electronic Stability Control error would not stay running checked battery cables fuses and restarted engine tried to back out of driveway engine would not go. Had jeep towed to Moore CDJR dealership where it was purchased from 9/2023 to have serviced found throttle body needs replaced dealership contacted several parts dealers, Mopar, and other dealerships etc. to locate the part needed was advised couldn’t find the parts needed for the repair. Contacted service department and they advised they were calling National Auto Care my extended warranty for approval for repair. My concern is if I had been driving 65 mph and it went out I would have been in a accident when the vehicle stopped functioning. Safety of myself and other drivers would have been compromised. This is the 2.0L Turbo motor and have been advised that there are several issues with this motor and should trade in vehicle. I don’t have that option and this is the only vehicle I have.