NHTSA Complaint #11589795 — 2017 TESLA MODEL X

This year Tesla has a known "acceleration shutter" due to the front CV joints' angle being too sharp causing premature wear. I have been dealing with this issue since the vehicle was new. Tesla has replaced my CV joints 5-7 times and during the repairs they have left bolts out of the vehicle, left bolts loose and damaged the front drive unit so much by bad repair jobs they have had to replace the front drive unit twice. In the most recent episode, the motor mount has cracked and was making a loud banging noise under acceleration and declaration. Most concerning is the fact I found some brake lines not in their keepers and they were rubbing on this mount. (I have photos). I have had my vehicle at 3 different Tesla service centers and at least two are inadequate. My concern, especially with the loose and missing bolts, is the sense of bad workmanship which could lead to a real problem in the future. I have, myself, fixed the brake line issue and tightened the motor mount bolt and the car is fine but don't know what else is not done properly, so I will be asking a service center (over , 100 miles away) to please check to make sure there isn't anything else loose due to the front drive unit being replaced. I also have another bad half shaft which was replaced about 10,000 miles ago back in October of 23'. I have pictures of all this nonsense if you are interested. But again, my concern is what if they leave something important loose that can kill someone. I've had many episodes of shoddy workmanship from two different service centers. Hundreds of miles apart. It appears to be either a training or culture issue. The jury is still out on the 3d service center, but it's not looking good at the moment.