NHTSA Complaint #11565048 — 2014 CHRYSLER 300

TRANSMISSION CONTROL MODULE AND VALVE BODY ASSEMBLY. There is a backorder(700) from the factory on this product and the wait is at least 3 months! This problem has been confirmed by the dealership as well as the backorder. The vehicle will not go in gear even with the engine running. The message displays as vehicle is already in desired gear even when it is not, and you cannot put it unto any gear even neutral, as it gets stuck in park!. The code is PO658, and the CHECK ENGINE light is illuminated and can happen without warning while vehicle is parked, stopped or idling so far as I experienced. The ignition will not turn off and the battery must be disconnected in order not to drain the battery. If this were to happen in traffic or or an intersection we all could have been KILLED. It has happened 4 times to us, Two times it started working on its own and Two times requiring a tow which cost me $600. Once at the dealer they charge a $140 non-refundable diagnosis fee and then can't fix the problem because they don't have the parts and can't get them. I think allowing Vehicles to have electronic shifting transmissions instead of manual shifters is a HUGE safety risk! The car only has 70K Highway miles on it and even if it was under warranty we can't get the darn parts. The dealer has to install it because it has to be programmed. The transmission is manufactured by ZF in Germany and they make others for several other car manufacturers. Chrysler uses this transmission across their entire fleet so this failure defect could show up in any of their product line