NHTSA Complaint #11426077 — 2015 FORD MUSTANG

The issue is the Brake Light switch stop pad on the brake pedal which is a rubber type of plug. At 70,000 miles the brake light switch stop pad cracked and fell into floor board (see pictures). When that happened, the RPMs dropped to idle speed and the car slowed down. After a few seconds, the car would pick up speed again only to repeat the event over and over again. I understand that when the brake light switch stop pad is missing and the plunger on the switch is fully out, the car thinks that you are applying the brakes. I was lucky, I was on a two lane road with no traffic, but I was headed to an inter-state with heavy traffic. Ford (nor does anyone else) does not sell just the rubber plug which fits on the brake pedal, but it will sell the complete brake pedal assembly. Not sure the reason that the brake pedal would require the hole that requires the rubber plug, but think that Ford should be responsible for the replacement or a better solution for the repair (Provide a replacement plug, not just the complete Brake pedal assembly. Thank you for you time in this matter. [XXX] PARTS OF THIS DOCUMENT HAVE BEEN REDACTED TO PROTECT PERSONALLY IDENTIFIABLE INFORMATION PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).