NHTSA Complaint #11030440 — 2006 CHEVROLET CORVETTE Z06

I NEVER RECEIVED ANY NOTICE FROM GM, BUT I BROUGHT IT TO THE DEALER'S ATTENTION WHILE I WAS IN FOR A RECALL REPAIR IN 2008. I TOLD THE TECH THAT MY TRACTION CONTROL, ACTIVE STABILITY CONTROL, WASN'T WORKING PROPERLY. WHEN I RECEIVED THE CAR BACK THE TECH SAID THE TRACTION CONTROL IS FIXED AND WORKING FINE. I DIDN'T SEE HOW HE COULD HAVE SAID THAT WHEN THE CAR NEVER LEFT THE SHOP. I REALIZE NOW THAT HE WAS AWARE OF SOMETHING THAT I WASN'T. THE TRACTION WASN'T FIXED, BUT I FELT THAT I CAN'T BRING IT BACK DUE TO INCOMPETENCE. I WENT TO FORUMS AND FOUND PLENTY OF COMPLAINTS FROM OTHERS. THEN I NOTICED THAT 2005-2006 CORVETTES WITH THE RPON37 STEERING COLUMN BUILT IN 2005 WERE RECALLED FOR THIS. NHTSA CAMPAIGN NUMBER WAS 10V172000 AND GM'S CAMPAIGN # WAS N100118. I CALLED GM THEY SAID I AM MISTAKEN MY CAR IS NOT AFFECTED WHICH IS [XXX]. I THEN FOUND FROM THE INTERNET THAT PART #19179794, CLIP, WAS USED TO FIX THE ISSUE. I THEN ORDERED ONE OF THESE AND FOLLOWED THE INSTRUCTIONS TO REPAIR IT AND FOUND THIS CLIP WAS INSTALLED, BUT IMPROPERLY HENCE THE REASON IT WASN'T FIXED BY THE TECH, BUT HE WAS UNDER THE IMPRESSION IT WAS SOLVED. I THEN REPLACED THE CLIP PROPERLY AND NOW IT'S OK. GM WAS VERY DIFFICULT AND DISMISSIVE DURING THE ENTIRE ORDEAL. LOOKING ON YOUR WEB SITE IT SPECIFICALLY STATES THAT MY VIN # DOES IN FACT FALL INTO THE SPECS OF YOUR RECALL. I AM GOING TO ENCLOSE A PHOTO OF THE BENT, IMPROPERLY, INSTALLED CLIP AND A PROPER PICTURE OF THE CLIP. ALSO THE HARNESS THAT NEEDS THE CLIP TO SHOW THAT THE BENT PRONG IS NEEDED TO REPAIR THE HARNESS. PARTS OF THIS DOCUMENT HAVE BEEN REDACTED TO PROTECT PERSONALLY IDENTIFIABLE INFORMATION PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).