NHTSA Complaint #10787327 — 2003 FREIGHTLINER SPRINTER 3500

TL* THE CONTACT OWNS A 2003 FREIGHTLINER SPRINTER 3500. THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 5 MPH, THE VEHICLE STALLED. THE VEHICLE WAS TOWED TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED THAT AN UNKNOWN FUSE NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED, HOWEVER, THE FAILURE RECURRED THE NEXT DAY. THE CONTACT REPLACED THE FUSE BUT THE FAILURE RECURRED. THE CONTACT ALSO STATED THAT WHILE DRIVING AT APPROXIMATELY 10 MPH, THE VEHICLE STALLED AND IT WAS DISCOVERED THAT THE SAME FUSE HAD FAILED. THE CONTACT REPLACED THE FUSE, HOWEVER, THE VEHICLE WOULD NOT START. THE VEHICLE WAS TOWED TO THE DEALER WHERE IT WAS DIAGNOSED THAT THE ELECTRONIC CONTROL MODULE NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED, HOWEVER THE FAILURE RECURRED THE FOLLOWING DAY AND THE SAME FUSE NEEDED REPLACEMENT WHICH CAUSED THE VEHICLE NOT TO START. THE VEHICLE WAS TOWED TO THE DEALER WHERE THE FAILURE WAS UNABLE TO BE DETERMINED BUT THE TECHNICIAN WAS ABLE TO START THE VEHICLE. THE FAILURE RECURRED AND THE VEHICLE WAS NOT ABLE TO BE STARTED. AS A RESULT, THE VEHICLE WAS TOWED TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED THAT THE ECM WAS MELTED AND NEEDED TO BE REPLACED. THE FAILURE RECURRED AFTER THE REPAIR AND THE VEHICLE STALLED. THE VEHICLE WAS TOWED TO THE DEALER WHERE IT WAS DIAGNOSED THE CRANK SHAFT SENSOR AND THE CAM SHAFT SENSORS NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED BUT WHILE DRIVING APPROXIMATELY 40 MPH, THE VEHICLE STALLED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 150,000.