NHTSA Complaint #10587375 — 2011 BMW 550I

I WAS DRIVING ON A RESIDENTIAL STREET AND SHIFTED INTO 3RD GEAR. THE CAR BEGAN TO BUCK VIOLENTLY. I PUSHED IN THE CLUTCH TO STOP THE BUCKING. I WAS APPROACHING AN INTERSECTION. I ATTEMPTED TO ACCELERATE AND THE GAS PEDAL WAS NON-RESPONSIVE. THE VEHICLE THEN INDICATED THAT IT HAD A DRIVETRAIN MALFUNCTION. I WAS ABLE TO PULL OVER, TURN THE CAR OFF AND BACK ON AND DRIVE 0.5 MILES TO MY DESTINATION. WHILE PARKED, THE PARKING BRAKE ALSO MALFUNCTIONED AND I WAS UNABLE TO TURN IT OFF. THE CAR WAS TOWED TO THE DEALERSHIP. THERE IS A SIGNIFICANT DESIGN DEFICIENCY WITH THIS VEHICLE. THE PROBLEM WITH MY CAR HAD TO DO WITH A BROKEN PLASTIC PART ON THE WATER CHANNEL THAT LEADS AROUND THE TRUNK. THE PLASTIC COVER IS SUPPOSED TO SNAP INTO A GROMMET THAT IS IN A HOLE, THUS SEALING THE HOLE FROM WATER. IN MY SITUATION, THE GROMMET WAS MISSING. GIVEN THE DESIGN OF THE PLASTIC PART, THERE IS NO WAY TO KNOW THAT THERE IS AN ISSUE WITHOUT REMOVING THE PLASTIC PART. THE HOLE THAT THE PLASTIC PIECE SNAPS INTO LEADS DIRECTLY INTO THE TRUNK. IN THE BOTTOM OF THE TRUNK ARE SENSITIVE ELECTRONIC MODULES THAT CONTROL THE FUEL MANAGEMENT SYSTEM AND THE PARKING BRAKE. THERE IS NO DRAIN IN THE TRUNK THAT WOULD ALLOW WATER TO LEAVE THE VEHICLE. MY VEHICLE WAS PARKED IN A PARKING LOT DURING A RAIN STORM. AS A RESULT OF THE DESIGN, I GOT WATER IN THE TRUNK, WHICH RUINED THESE TWO MODULES, RESULTING IN THE VEHICLE BECOMING DISABLED WHILE DRIVING. I BELIEVE THAT THIS IS A SIGNIFICANT SAFETY ISSUE FOR THE FOLLOWING REASONS: I) AS A CONSUMER, I HAD NO IDEA THAT THE ELECTRONICS THAT ENABLE THE VEHICLE TO MANAGE FUEL WERE LOCATED IN THE TRUNK; II) THE DESIGN OF THE WATER CHANNEL AROUND THE TRUNK SEEMS INADEQUATE GIVEN THAT ANY FAILURE OF THE PLASTIC SHIELD / GROMMET COMBINATION WOULD LEAD TO WATER IN THE TRUNK AND EXPOSE THESE CRITICAL COMPONENTS. *TR