NHTSA Complaint #10562846 — 2005 CHEVROLET SILVERADO 1500

WITH THE HEATER ON HIGH (SETTING 5), THE FAN STOPPED BLOWING HEAT. I THEN SET THE BLOWER TO SETTING 4, AND THE FAN WORKED FINE. AS SOON AS I THEN PUT THE FAN BACK TO 5, I WOULD HEAR A CLICK BUT THE FAN WOULD NOT WORK AT ALL. I THEN BEGAN TO FIDDLE AROUND WITH THE CONNECTOR THAT IS UNDER THE PASSENGER SIDE DASH WHICH POWERS THE FAN. IF I MOVE THE ONE WIRE AROUND, THE FAN WOULD INTERMITTENTLY WORK WHILE ON SETTING 5. I UNPLUGGED THIS CONNECTOR FROM THE BLOWER MOTOR, NOTICED THAT THE ONE WIRE SEEMS AS IF IT WAS CAUSING A SHORT (THE WIRE WAS SOMEWHAT BLACK FROM OVER CURRENT). I REMOVED THE PIN FROM THE CONNECTOR, RECRIMPED AND SOLDERED IT. WORKED FINE UNTIL A FEW WEEKS AGO WHEN THE FAN ONCE AGAIN BEGAN TO STOP ONLY ON SETTING 5. I AM ASSUMING THAT THE PROBLEM IS ONCE AGAIN THE CONNECTOR THAT GOES TO THE BLOWER MOTOR POWERING THE FAN RESISTOR. I SAW A FEW REPORTS OF THIS ON HERE ABOUT VEHICLE FIRES ALL OF WHICH POINT TO THIS CONNECTION BEING BAD. SO I THOUGHT I WOULD SUBMIT THIS AS WELL DUE TO THE VAST AMOUNT OF ISSUES I HAVE HAD WITH THIS TRUCK. *TR