NHTSA Complaint #11468771 — 2007 VOLKSWAGEN PASSAT

To start off, this car has common failures of the High Pressure Fuel Pump Cam Follower. This poses serious risk of damage to the engine when the follower is blown throw and the car goes into limp mode and if this happens on road it could be catastrophic. There were no warnings that this was the issue besides researching videos on YouTube while getting a fuel pressure code to find out the cam follower was completely blown throw which means my engine has MANY METAL pieces inside of my engine. If I did not catch this soon the next failure would’ve been the CAMSHAFT. The camshaft going bad at and given moment could also be catastrophic on the road and possibly even spark a fire. Another issue is with the timing chain on specific FSI engines. If this chain snaps mid drive then your engine could potentially blow in the middle of the road causing an accident. This problem is known by Volkswagen and they have yet to take serious action in regards to this safety hazard. Another potential for catastrophic events is the wiring harness specifically the one that runs under the Vacuum pump. These wires are covered in oil from the vacuum pump being prone to leaking and any fluid that goes on top of it. I also discovered that near my ECU to that wiring harness there was a spot of gasoline in which I was able to determine when I smelt the fluid with a glove on of course. This year make and model of Volkswagen can cause serious harm to those driving ESPECIALLY on the high way. The wiring harness and all components around it soak with oil and when you take off the manifold fuel also gets all over it even when you try to prevent it as much as you can. This has caused increased idle in my vehicle while driving with and EPC light that makes the car stall out of no where. If it happened when I was turning my wheel it could’ve caused an accident on the road or even a driver to have road rage behind me. Please help myself and fellow Passat owners of this year stay safe.